Longines Logo Watch Stand

Simple Longines logo watch stand. For assembly just pop the logo into the base and the stand into the slot at the top. Due to the logo being super thin at the center I had to do it this way, but open to suggestions to improve. Printed on A1 Mini, standard 15% infill for both, tree support for the stand. I have included various sizes of the stand to support different wrist sizes. Only the top is scaled, the stem is the same for all of them. For my almost 7 inch wrist I am using the 95% scaled version but have applied a piece of faux leather tape on the surface (link below). Without the tape should use 98 percent for a near 7 inch wrist. I have made some other brands too. Let me know if you would like one. https://www.amazon.ca/dp/B0D2XQRBMM?ref=ppx_yo2ov_dt_b_fed_asin_title