Thingiverse
Longsword hilt grip basic
by Funderaren
19
Downloads
13
Likes
0
Makes
Grip for a longsword foam waster.
I had to scale it +5% in X and Y due to hole shrinkage.
To be used with a 8mm glassfiber core
As a beginner HEMA practitioner I found the lack of local resources necessary to make my own gear.
I browsed for Longsword wasters and there are lots of good quality stuff to buy. Problem is that I can not go and pick up any and get a feeling for the quality.
My solution to buying blindly is to DIY. What I Make I can fix if they get broken.
I had to scale it +5% in X and Y due to hole shrinkage.
To be used with a 8mm glassfiber core
As a beginner HEMA practitioner I found the lack of local resources necessary to make my own gear.
I browsed for Longsword wasters and there are lots of good quality stuff to buy. Problem is that I can not go and pick up any and get a feeling for the quality.
My solution to buying blindly is to DIY. What I Make I can fix if they get broken.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
