Loop Quiet Earplugs Keychain Case

UPDATE: Check out the new screw-top lid version here: https://www.printables.com/model/844317-loop-earplugs-screw-top-lid-case


Remixed jecoffey's awesome design, made it a little thinner and a little shorter, removed the loop and put holes in the top for pullchain.

Exterior case prints hole-down with a brim, no supports needed.

Interior holder can print either way down, but if you print holes-down don't use a raft (learn from my mistakes). Minimal supports are needed (see photos).

Don't print them at the same time, PETG is too stringy.