Thingiverse
Loose bipod/monopod
von KeiserZA
24
Downloads
22
Likes
0
Makes
I personally dont like attached bipods on a airsoft sniper. It increases the weight, and can be redundant. They are, in my opinion, also over priced for the little that I personally use them.
As such I made this simple design of both mono and bipod.
The resting post has a opening of 4cm. I recommend adding some soft material inside, such as canopy tape or foam tape.
the holes for leg attachment is 1cm - to take a wooden dowel stick of 1cm in diameter.
The feet are not a requirement, as the sticks should suffice on their own - just added them for someone that may want feet.
This, like most of my other stuff, is slap dash. But hopefully effective for someone else as well.
I carry only the resting post with me, and a single 10 cm dowel stick.
As such I made this simple design of both mono and bipod.
The resting post has a opening of 4cm. I recommend adding some soft material inside, such as canopy tape or foam tape.
the holes for leg attachment is 1cm - to take a wooden dowel stick of 1cm in diameter.
The feet are not a requirement, as the sticks should suffice on their own - just added them for someone that may want feet.
This, like most of my other stuff, is slap dash. But hopefully effective for someone else as well.
I carry only the resting post with me, and a single 10 cm dowel stick.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!