Thingiverse
Lorax Glasses
by tcaruth
31
Downloads
14
Likes
1
Makes
*Modeled by request.*
Prints in three pieces. The hinges should be assembled with small screws or short pieces of filament.
*Scaling*
Default is 134mm from edge to edge, which will likely fit most adults. If you aren't sure what size, I suggest printing a few layers of the original glasses scaled 80-90% and stopping to check the size on their face before printing a scaled version of these.
Prints in three pieces. The hinges should be assembled with small screws or short pieces of filament.
*Scaling*
Default is 134mm from edge to edge, which will likely fit most adults. If you aren't sure what size, I suggest printing a few layers of the original glasses scaled 80-90% and stopping to check the size on their face before printing a scaled version of these.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
