Love in flames HueForge

Picture source - author: Geri Paventy Then used HueForge v0.9.1 to create the model. The Model is 150x150mm in size. You can only modify the X and Y dimensions. Do not adjust the height (Z) in your slicer! The layers would not be correct. You may print at higher layer heights below the Base Thickness of 0.48mm. The Max allowed Thickness is 2.32mm and the Actual Thickness is 2.32mm. It is possible to print without material system by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support. These were my settings and colors for my print that you see in the picture. Your results may be depending on the filament you use. PLA Anycubic Black Transmission Distance: 0.3 PLA Elegoo + Orange Transmission Distance: 6 PLA Elegoo + Yellow Transmission Distance: 4 PLA Elegoo Basic White Transmission Distance: 7 This print uses 4 unique filaments   Swap Instructions: Start with Black At layer #9 (0.8mm) swap to Orange At layer #17 (1.44mm) swap to Yellow At layer #21 (1.76mm) swap to White for the rest.