Thingiverse
Low overhang threaded rod
por joehann
3.1k
Descargas
2.2k
Likes
10
Makes
Troubles with printing the threaded rods?
This is a low overhang design which was also used for the G-Clamp.
http://www.thingiverse.com/thing:1673030
Print single rods and plug them into the sliding jaw or use the
combined version. The new main gears are required as well.
This is a Remix of Yet ANOTHER Machine Vise by TheGoofy
https://www.thingiverse.com/thing:2064269.
Unchanged and missing files are available there!
This is a low overhang design which was also used for the G-Clamp.
http://www.thingiverse.com/thing:1673030
Print single rods and plug them into the sliding jaw or use the
combined version. The new main gears are required as well.
This is a Remix of Yet ANOTHER Machine Vise by TheGoofy
https://www.thingiverse.com/thing:2064269.
Unchanged and missing files are available there!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
