Thingiverse
Low Poly Backpack
von 3D_Prime
228
Downloads
190
Likes
0
Makes
Version 3 Low Poly Backpack designed to print on a Creality CR-10 or bigger (280mm height). Can be printed in either one or two pieces. Designed to fit 3/8ths inch rope as shoulder straps.
We printed with PETG, each half takes just under 1 kilo if printed seperately (not including the door)
When printing the bag in one piece, there are bumps on the bottom to keep it out of deeper puddles. If you don't want the bumps, you can lower the print below the build plate on the slicer to cut them off. If you do want them, print the bag upside down.
Recommended filament: PETG, ABS or another high temperature resistant filament when being used outdoors.
Settings may vary depending on how strong you want the bag. Check our print settings in the print settings area.
The bag is a project that we want to see grow, change and be added to by the community. We plan on adding optional accessories such as but not limited to: Vape holster, a hat hook, interior lighting, charging capabiliti
We printed with PETG, each half takes just under 1 kilo if printed seperately (not including the door)
When printing the bag in one piece, there are bumps on the bottom to keep it out of deeper puddles. If you don't want the bumps, you can lower the print below the build plate on the slicer to cut them off. If you do want them, print the bag upside down.
Recommended filament: PETG, ABS or another high temperature resistant filament when being used outdoors.
Settings may vary depending on how strong you want the bag. Check our print settings in the print settings area.
The bag is a project that we want to see grow, change and be added to by the community. We plan on adding optional accessories such as but not limited to: Vape holster, a hat hook, interior lighting, charging capabiliti
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
