Cosplay STL Download - Low-Poly Deer Maskby Perihelion Prints

Low-Poly Deer Mask by Perihelion Prints======Ready to print and wear or display.Scaled to fit most adult heads, but you may need to do a test print to confirm fit.For attachment to your head, use cord or ribbon. You can measure enough to go around your head, then make two strips of that length and attach them to the sides of the mask. Hot glue works well. Then you can position the mask over your face, pull the cord or ribbons back, and make a knot behind your head. Or you can edit the file to come up with your own solution.You may also want to put some foam on the forehead area or around the nose for a more comfortable fit, but it should not be required.======"Trapless sundress" used in demo render (https://skfb.ly/6VMr7) by yang_xiaogang is licensed under Creative Commons Attribution (http://creativecommons.org/licenses/by/4.0/)======0.20mm layer height recommended.Organic supports recommended. You may need to slightly adjust the orientation of the mask to fit it on your printer's bed, but try to print it as upright as possible for best results.This is a large model which may not fit in one piece on your printer. You may print the "Top" and "Bottom" pieces separately.PLA/PETG recommended.Filament Usage (estimated): 190g (110g for bottom, 80g for top)Printing Time (estimated): 12h45m (7h for bottom, 5h45m for top)^ Estimates based off slicing the top and bottom separately for a Prusa MK3.9. Your mileage may vary.