Thingiverse
Low Poly DireWolf with extra tail support
von gordonendersby
65
Downloads
48
Likes
2
Makes
Derived from NathanSquire67's Low Poly DireWolf
http://www.thingiverse.com/thing:358837
My Son asked me to print this for him but after 2 attempts the tail would not stay attached to the bed while printing and the print failed.
Im using cura with supports support but the tail did not have any support to keep it still till it was joined to the main body of the model.
So I imported it into freecad and added a little support to the tail.
Freecad files included
http://www.thingiverse.com/thing:358837
My Son asked me to print this for him but after 2 attempts the tail would not stay attached to the bed while printing and the print failed.
Im using cura with supports support but the tail did not have any support to keep it still till it was joined to the main body of the model.
So I imported it into freecad and added a little support to the tail.
Freecad files included
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
