Low poly elephant (surface quality/adhesion test)

LOW POLY ELEPHANT DECORATION (Surface quality/Adhesion test)This low poly model of an elephant is made so it has very 4 small paws touchign the build plate to test adhesion when it starts to build up the body. SUPPORT IS REQUIRED, BE CAREFUL REMOVING IT AROUND THE TRUNK. The sharp edges of the low poly models make it a perfect test for silk and shiny filaments to see if there's any vibration when it goes around the corner. (as you can see from the photo i had quite some). Prints can be scaled up if needed (don't know how much smaller it can be made before the trunk becomes too thin). The print takes about 1.5h print time with very little infill (can be adjusted to needs). if people like the model as a decoration I'll think of adding a version with a tealight holder on top! Boost MeIf you like my models boosts are appriciated! I keep all my models on makerworld and free!