Thingiverse
Low-Profile Atomic Pi Case
von Physics_Dude
31
Downloads
20
Likes
1
Makes
A no-nonsense clam shell style Atomic Pi case in two flavors. **1.5mm walls and 0.75mm walls** (half thickness). Its vented too!
Designed for use with the official "DLI Flush Mount Baby Breakout Board" addon which adds a barrel jack, two LEDs and some GPIO pinout headers.
This breakout board is NOT required though. You can glue in your own connector and LEDs.
I received mine through this kit: https://www.amazon.com/DLI-Atomic-Pi-Peripheral-Camera/dp/B07DVYDDV8/
I made a case that supports SATA SSDs too: https://www.thingiverse.com/thing:3850448
Update (23 March 23):
Fusion360 and STEP source files included (these match the SATA drive revision in their supplied state).
Designed for use with the official "DLI Flush Mount Baby Breakout Board" addon which adds a barrel jack, two LEDs and some GPIO pinout headers.
This breakout board is NOT required though. You can glue in your own connector and LEDs.
I received mine through this kit: https://www.amazon.com/DLI-Atomic-Pi-Peripheral-Camera/dp/B07DVYDDV8/
I made a case that supports SATA SSDs too: https://www.thingiverse.com/thing:3850448
Update (23 March 23):
Fusion360 and STEP source files included (these match the SATA drive revision in their supplied state).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
