Low Voltage Cutoff Case

This is a vented case for a ["Digital Low Voltage Protector Disconnect Switch Over Discharge Protection Module" found on Amazon](https://www.amazon.com/gp/product/B07R8C9JW9/). Sold by many sellers and should work with any of them. Both the top and bottom of the case have vents cut in them, and the holes for the power wires are large enough that they shouldn't have an issues with larger wires.

No screws or other hardware needed, this case has built in spacers to keep the module off the bottom of the case, and also has pins coming out of those spacers to secure keep the module secured. The top of the case just slides on and stays secure on its own. Can be a little difficult to remove sometimes, so there's a half circle hole on one side of the lid to allow for prying the lid off with a flat head screwdriver if needed.

I have only printed this with ApolloX ASA filament, which has virtually no warping and prints very accurately in all 3 directions. PLA should print fine too though I