Thingiverse
LowDrag_Quad
von jrho
75
Downloads
81
Likes
0
Makes
Normal QUADs have a negative lift - this QUAD has positive lift, and les drag than normal QUADs. - The model is prepared for FPV with a little Sony camera in the Nose!
The distance from propeller spinner to oppersite propellerspinner is 250 mm and the weight ready for flight 530 Grams.
It can be printed on printers with a printspace around 190x190x190 mm - The body consists of 4 parts - it would be nicer with only 2 parts but thats not possible with a Prusa i3.
Its created for Naze32 or CC3D flightcontroller and Power Distribution Boards for the same, 3s batteries and kv2300 motors with a fitting propeller. - Use the classical round toothpicks in the holes in the body to keep the bodyparts aligned!
When You setup the flight controller, it might be an idea to lift the front a bit, so the wings is vertical when the QUAD is supposed to be hanging on the same spot!
Vitamins:
FlightController:
http://www.aliexpress.com/item/Naze-32-Naze32-Full-with-Mag-and-Baro-Sensor-Rev-
The distance from propeller spinner to oppersite propellerspinner is 250 mm and the weight ready for flight 530 Grams.
It can be printed on printers with a printspace around 190x190x190 mm - The body consists of 4 parts - it would be nicer with only 2 parts but thats not possible with a Prusa i3.
Its created for Naze32 or CC3D flightcontroller and Power Distribution Boards for the same, 3s batteries and kv2300 motors with a fitting propeller. - Use the classical round toothpicks in the holes in the body to keep the bodyparts aligned!
When You setup the flight controller, it might be an idea to lift the front a bit, so the wings is vertical when the QUAD is supposed to be hanging on the same spot!
Vitamins:
FlightController:
http://www.aliexpress.com/item/Naze-32-Naze32-Full-with-Mag-and-Baro-Sensor-Rev-
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
