lower support for ams side spool holder

This does not work if the spool is mounted directly on the mount (as low as the AMS spools) as these supports get in the way!I modified the things below to hang the spool mount higher so it could facilitate 2kg spools. These supports are necessary because 2kg spools are too heavy for the AMS spool holder just clamping to the thin side wall of the AMS. lower support for ams side spool holder for a combination of these things:https://makerworld.com/de/models/1815860-h2-simple-ams-flipper#profileId-2221595Leaves 4,5cm room for supports AMS2→edge of H2(x) printer https://makerworld.com/de/models/250080-ams-side-mount-spool-holder?from=search#profileId-266354Provides base plate to clamp on AMS side walls to connect some spool holder to. This supports the side mount against the base plate so that stress on the thin AMS walls is relieved. Print in PLA+ or PETG. Screws are 1x M4x30 for each support used.