Lowly Worm apple helicopter DUPLO

My own custom designed Lowly Worm apple helicopter for DUPLO.

It's not exactly plug and play 😅

You will need the following to assemble:

- Super glue (cyanoacrylate)
- 3.2 or 3.3mm drill bit
- M4 thread tap
- 10mm M4 countersunk bolt
- Small round file

For glossy finish you will need:

- 120-5000 grit wet sanding paper (perhaps it can be polished after a lower grit than 5000, but that's what I used)
- Autosol Plastic Polish

I used organic supports for the Apple_top so the Dash Board is unaffected.
I used brim for the studs.

To avoid supports on, the bottom of the apple consists of four parts glued together: Apple_bottom, Bottom_lip and 2 x Bottom_studs.

I glued them with Super glue (cyanoacrylate)

The same goes for the rotor, where the hub with supports for the blades are glued on.

I have uploaded prints for templates/jigs for glueing on the Bottom_lip and Rotor_hub, to make sure they are glued on precisely. (see pictures)

Need to glue on the Lip_bottom on the Apple_bottom bef