LTS Respooler Linear Rail Upgrade

Jan 12, 2026 Added left and right LTS Respooler frames with holes for this linear rail upgrade. Changes to LTS Respooler v3 FramesAdded bearing removal holes for wornshaft bearings,Opened all screw holes to accept heat inserts, use M3 4.2mm OD by 10mm length heat inserts.Added two holes accross the bottom for cable management.Added two holes to accept my Linear Rail Upgrade. 1) Increased width of Filament Guide to accept Linear rail bolt pattern. Use 100mm LML9B linear rail. https://www.amazon.com/dp/B0DM7TGVYJ?ref=ppx_yo2ov_dt_b_fed_asin_title 2. Reduced the two bores in the filament guide for the worm gears by 0.2mm. 3. Created end mounting plates. Instructions, Install 4 M3x5x5 heat inserts into the end plates. Sand existing worm gears smooth and verify that they fit the modified filament guide. Assemble everything, Either: Mark the location of the screw holes from the backside of the end plates onto the existing side frames. and Drill the four mount holes in the frame at 3.5mm to 4