Luffy Bookmark - 4 Colours

If you would like to sell my Hueforges a Commercial Licence is available on Patreon. Link is in my bio. Do not sell my prints without it please. Important:You CANNOT adjust the Z scaling on a Hueforge. It will not come out as intended. You can change the X and Y values to scale the picture up or down though.To ensure that the print looks the same as mine you must use the same filaments I did (listed below). If you do not, your results will not be exactly the same as shown.What you see in the slicer will not accurately show the final result. Do not worry about this. Hueforge uses colour blending, but it does not show in the slicer.You may see a floating regions error. This can be ignored. Printing InstructionsPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Remember to select the correct plate type for your printer. I have used a height range modifier in the object settings for quicker printing. The layer swap numbers in the print profile will not match the