Thingiverse
Luke Skywalker Lightsaber
by Keyang
81
Downloads
75
Likes
0
Makes
This is one of my first Autodesk Inventor projects that I worked on the summer of 2016. This Luke Skywalker Lightsaber is by far my favorite hilt, so I decided to create it. I was inspired to make replica props for Star Wars because I've always dreamed of owning props like these.
Every part of this hilt was manually made by me using ONLY Autodesk Inventor, and is in no means an actual 1:1 replica of the original. However, I've done my best to create one that is far more accurate than others that I have seen on Thingiverse. My design was based off of the first image, although not 1:1, it's pretty close.
The Completed Project can be viewed above.
10/10/16 EDIT
I've added a new file to create a better front section for the Lightsaber. I've also replaced the original Thing file with a new one, titled: High Res Hilt. This should allow for better resolution prints, as the flat sections do not rely on support material to create, but rather the flat bed surface.
As you can see,
Every part of this hilt was manually made by me using ONLY Autodesk Inventor, and is in no means an actual 1:1 replica of the original. However, I've done my best to create one that is far more accurate than others that I have seen on Thingiverse. My design was based off of the first image, although not 1:1, it's pretty close.
The Completed Project can be viewed above.
10/10/16 EDIT
I've added a new file to create a better front section for the Lightsaber. I've also replaced the original Thing file with a new one, titled: High Res Hilt. This should allow for better resolution prints, as the flat sections do not rely on support material to create, but rather the flat bed surface.
As you can see,
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
