Lulzbot Taz 6 Printed Solid Top Plexiglass Retainer Clips

Hi there,

I have the Acrylic (Plexiglass) Enclosure from Printed Solid for the Taz 6. With that enclosure, there is a piece that sits on the top of the Taz 6 where filament is fed through. That piece tends to slip off and interfere with the print on occasion.

These clips are designed to prevent that.

To install:
- Remove the two inner-side M5 screws that secure the Z-Upper top plate into the T-nuts from both left and right sides.
- Install the plexiglass top piece from Printed Solid
- Install the clips over-top of the holes revealed in Step 1.
- Re-install the two M5-screws (now M5x12mm; set aside the M5x10mm in case you want to undo this later), slipping them through the retainer clips and back through into the T-Nuts.
- Tighten firmly
- Voila!

Please note, You will need to switch the M5x10 screws that come pre-installed with M5x12mm BHCS black oxide screws.



* Use of these clips is done at your own risk. I accept no responsibility for these or your use of the