Lyman Lube Sizer Push Through Adapter

Have you switched over to Hi-Tek or powder coating your cast bullets but still have your lubrisizer?

This adapter guides bullets outward and down as they pass through the die so that they don't stack up and jam.

I am able to nose down size about 15 lbs of 9mm per hour pretty easily using this.

Directions:
1 - remove sizing die (remember to warm up the press if it has hard lube!)
2 - remove push out rod (12 on parts diagram)
3 - remove the pin from the die
4 - install the die
5 - install the adapter below die and secure with adjusting screw (10)

Once you are finished - use the die pin to push out the last round - Caution: only push the pin flush to the top of the die.

Parts diagram: https://www.lymanproducts.com/4500-lubricator-sizer-replacement-parts.html

Tested on a Lyman 45 but should work on the 450/4500

If any of my designs help you out, a comment is appreciated and tips are always welcome.