Thingiverse
M.2 SSD Standoff
door Rectangle
3
Downloads
14
Likes
0
Makes
This is a replacement M.2 standoff mount for boards which are missing the thread to install the standoff. See images for example.
I received a replacement motherboard for my Dell Optiplex 5250 AIO computer which was missing the thread for the M.2 SSD standoff to mount to. There is a thread on the smaller 2242 position, but my SSD is larger than that. This was intended to be temporary, but it worked better than expected, so I will keep it installed.
I recommend changing your print resolution to 0.16 or smaller.
v2 and v3 of the standoff provide a few changes:
-a longer thread for the 3d printed nut
-increases the screw hole size at the top
-shortens the standoff size so the SSD should sit at less of an angle.
I have v1 installed which works fine. I would try v3 if I were to print it again.
I received a replacement motherboard for my Dell Optiplex 5250 AIO computer which was missing the thread for the M.2 SSD standoff to mount to. There is a thread on the smaller 2242 position, but my SSD is larger than that. This was intended to be temporary, but it worked better than expected, so I will keep it installed.
I recommend changing your print resolution to 0.16 or smaller.
v2 and v3 of the standoff provide a few changes:
-a longer thread for the 3d printed nut
-increases the screw hole size at the top
-shortens the standoff size so the SSD should sit at less of an angle.
I have v1 installed which works fine. I would try v3 if I were to print it again.
Rectangle publiceert ook op
21 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
