Thingiverse
M-Lok Wall Mount Flush
von ZoozyUSA
0
Downloads
11
Likes
0
Makes
About:
I designed this M-Lok wall mount. I only have one "thing" with M-Lok so I hope it's standardized.
I drilled mine into a stud, and I've had mine on my wall for a while holding about 8lbs with no problems.
The bottom should be oriented with the 2 T's on top, and the empty space on the bottom; but you'll figure it out!
They can be a little stiff at first to slide on. I like to hit the edges, and top of the T with a wire wheel to make it easier at first.
I print in the orientation I have them saved as; at 100% infill.
Let me know what you think!
I designed this M-Lok wall mount. I only have one "thing" with M-Lok so I hope it's standardized.
I drilled mine into a stud, and I've had mine on my wall for a while holding about 8lbs with no problems.
The bottom should be oriented with the 2 T's on top, and the empty space on the bottom; but you'll figure it out!
They can be a little stiff at first to slide on. I like to hit the edges, and top of the T with a wire wheel to make it easier at first.
I print in the orientation I have them saved as; at 100% infill.
Let me know what you think!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
