M!N!MAL 4 - Raspberry Pi 4 Case

**Design**
This is the reduced to the max case / housing / sleeve for the Raspberry Pi 4 in the version without cooling (we have another model that is prepared for cooling and heatsink), less than that is hard to imagine. A foldable print in place housing with live hinge that is less than 2mm bigger than the Raspberry itself. All interfaces are accessible and the board itself is covered and protected. Above that it prints as one piece, the assembly is easy and no tools or screws are needed. Just print (in less than an hour) and use…
The design does consist of a frame and the top and bottom shells, which do have subparts that can provide openings to all interfaces on the board (GPIO, DSI, CSI, Reset, Pin) if removed from the part before printing.
The shell itself can be printed without perimeters and top / bottom layers, just infill, and will than contribute to maximize the airflow.

**Construction**
The case itself has a wall thickness of 0.8mm, optimized for printing with 0.4mm