Thingiverse
M12 Threaded Rod Discarding Sabot
8
Downloads
9
Likes
0
Makes
Based off the M1A1-2 Abrams' 120mm main guns' APFSDS.
3 pieces lock onto an M12 threaded rod and will discard when sufficient airflow has been reached.
A lacky band on the rear is needed, one in the middle may also be used.
Designed to complement my other thing; the M12 Stabilizer Fins.
Scaling will not work due to the thread.
O,D 47mm (little bigger than a Golfball) to accommodate similar barrels.
SEGMENTS MAY BECOME LOOSE DURING PRINT.
(Did not cause an issue; I wedged stuffed in between segments during the print though...lol)
3 pieces lock onto an M12 threaded rod and will discard when sufficient airflow has been reached.
A lacky band on the rear is needed, one in the middle may also be used.
Designed to complement my other thing; the M12 Stabilizer Fins.
Scaling will not work due to the thread.
O,D 47mm (little bigger than a Golfball) to accommodate similar barrels.
SEGMENTS MAY BECOME LOOSE DURING PRINT.
(Did not cause an issue; I wedged stuffed in between segments during the print though...lol)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
