M18 Throttle Controller Holder

Mounts an M18 throttle controller in the pop down storage compartment on the driver's side. Keeps it secure and within easy reach while out of sight.

May fit other similar platforms such as the Isuzu DMax and Mazda BT-50 but has only been tested on the Colorado.
Will friction fit in place, however you can use double sided tape on the back of the controller for a more secure hold.

Print Settings
Material: PETG or ABS (I have also done in PLA+ and its held up fine.)
Infill: 20%
Supports: Tree, print with face down.

Installation Note:
You will need to drill a small hole in the rear of the storage compartment to route the controller cable through.