Thingiverse
M2 Micro Machinist Jack
by mrmaigo
3
Downloads
3
Likes
0
Makes
Needed to level a project real quick/dirty and all I had is some M2 caphead screws and some nuts.
Height Range: 31 to ~53mm
M2 caphead screws 10-25mm, M2 nuts
Print with brim. 37 minutes/1.86m at 0.3mm/50mms/3walls
Update 1: First one turned out fine, second print not so much, didn't like the overhang for the nut. Guessing the temp was too high for a different filament. Little tweaky-tweaky.
Height Range: 31 to ~53mm
M2 caphead screws 10-25mm, M2 nuts
Print with brim. 37 minutes/1.86m at 0.3mm/50mms/3walls
Update 1: First one turned out fine, second print not so much, didn't like the overhang for the nut. Guessing the temp was too high for a different filament. Little tweaky-tweaky.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
