M22 Powerpole Mount

This is a M22 size panel mount adapter for standard 15-45A Powerpoles commonly used in amateur radio.
When installed the connector is basically flush with the front of the mounting adapter, I've tested this with connectors with the typical rubber strain relief and there's plenty of clearance.

Thread pitch is 2 mm to simplify printing.

The design includes a screw that holds the Powerpole including clearance for the dovetails ensuring it can only be inserted one way.
The screw includes two flats spaced at 19mm (3/4") to simplify installation.
A matching nut is also included for printing, a 26mm wrench can be used for tightening.

The rear port is large enough to insert the wires after installation if desired.
The Powerpole can either be glued in from the back, or retained using an M2.5 screw through the cross-hole in the screw.

To use the cross-hole you can install a DIN912 style M2.5x10-16 screw and rely on a friction fit.
Optionally you can install a standard M2.5 br