M3 Predator Holster

This is a holster for [ryanrybot's M3 Predator Upload](https://www.thingiverse.com/thing:5523782) in my own design, claiming no screen accuaracy, but with the goal in mind not to hide the prop.
>ATTENTION: your prop should be glued properly otherwise the lower sideparts could pop.

###Printing
I designed to be printable without supports

### Lining

I glued 2mm (rubber-)foam to the contacting parts to get a decent fit between holster and prop, DON'T SKIP IT the fit will be horrible and you paint will scratch.


### Mounting
either 3 of the bolt down pads to molle using 3 M6x12 screws and nuts (I marked the holes), use Pracord to do some webbing or come up with an even better idea, i left you plenty 6mm holes.

The picture shown has the mounting offset and freshly dilled holes, but thats changed in this release