Thingiverse
M365 Phone stand
by William972
10
Downloads
10
Likes
0
Makes
Original model : https://www.thingiverse.com/thing:4433728
I've just separated the two rods of the jaw to make them screwable
It allows to make them stronger by printing them separately with a higher infill (I've printed them in 100% personally).
I personally recommend to print the screw and the threaded shaft in PETG and/or with higher infill.
20-30% infill is ok for the rest
I've just separated the two rods of the jaw to make them screwable
It allows to make them stronger by printing them separately with a higher infill (I've printed them in 100% personally).
I personally recommend to print the screw and the threaded shaft in PETG and/or with higher infill.
20-30% infill is ok for the rest
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!