Thingiverse
M3D Pro Spool Holder (Customizable)
door urish
21
Downloads
7
Likes
1
Makes
This spool holder is intended for the M3D Pro printer, and sits on top of the unit, above the extruder, and using the printer chassis as base.
These are brackets only. Two sets are needed, one for each side, then simply add any dowel, rod or tubing of your choosing to complete this thing. Use the customizer on the right and select the tubing diameter you plan to use for the vertical risers and top axle, and the model will adapt. Be careful not to make the vertical fit too snug, or the brackets may split apart.
The vertical risers can be anything that make it tall enough to clear the printer and fit your spool size, minimum 3" recommended; I use 6" vertical risers.
The top brackets hold a horizontal axle, which can easily lift out to change filament. The horizontal top tube needs to be 8.5" in length, and can fit multiple spools.
These are brackets only. Two sets are needed, one for each side, then simply add any dowel, rod or tubing of your choosing to complete this thing. Use the customizer on the right and select the tubing diameter you plan to use for the vertical risers and top axle, and the model will adapt. Be careful not to make the vertical fit too snug, or the brackets may split apart.
The vertical risers can be anything that make it tall enough to clear the printer and fit your spool size, minimum 3" recommended; I use 6" vertical risers.
The top brackets hold a horizontal axle, which can easily lift out to change filament. The horizontal top tube needs to be 8.5" in length, and can fit multiple spools.
urish publiceert ook op
3 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
