m3rd3ka cazimi

a very light all-in-one 144mm frame for the e011 flight controller.

the mounting posts are 29mm apart, and 2mm diameter. note you must remove the battery and the motor sockets to install the board :)

adds: about finished with teh first build (8520s).. its extremely tight getting anything in the frame.. fc, (M7 lens size) camera, and (eachine) vtx.. not for teh impatient. thoughts: i did not, but its a good candidate for putting teh crystal under teh board. i soldered my motors directly, however teh motor sockets could be added upsidedown once the board is installed. its that tight :)

the "toes" are to help hold the arms in place during printing and are not intended to be part of the finished piece. please note that this design is intended to sustain flight and not impact :)

information.txt contains special license conditions necessary for retailing this item or any derivative. they are somewhat bizarre i suppose but not especially difficult or time consuming.

FIRST FLIGH