Thingiverse
M5 nut driver
von Ryjuuuhn
98
Downloads
48
Likes
0
Makes
Used to tighten m5 nuts into hard to reach spots.
This one is also available in m3 size
Print the part with wide flat part to the bottom.
Print with slow speed, because the printer starts to oscillate if you print too fast.
If the fit with the nut is too loose, decrease the XY dimensions.
If the fit is too tight, increase the XY dimensions
This one is also available in m3 size
Print the part with wide flat part to the bottom.
Print with slow speed, because the printer starts to oscillate if you print too fast.
If the fit with the nut is too loose, decrease the XY dimensions.
If the fit is too tight, increase the XY dimensions
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!