Thingiverse
M6TR Print In Place Diffuser
door gokitty199
0
Downloads
0
Likes
0
Makes
A few changes from the original. No the polycarbonate does not block the IR laser. The biggest one being it is setup to accept a diffusor that you can make yourself out of 0.093in or 2mm thick polycarbonate (don't use acrylic, polycarbonate is much tougher). The other changes are trimming away material on the corner closest to the picatinny rail you would mount the unit on. I have my unit sitting flush with the end of my handguard and this gives it enough room (still a snug fit, more material could be removed all around). The mounting tabs have been lengthened a few mm so it is easier to flip the cap on/off. The large inside ring that sits inside the cavity of the LAM has been shortened quite a bit as well for the same reason.
Materials:
I printed mine out of generic TPU, strength here is plenty.
I found my 0.093in 8x10in sheet of polycarbonate at Lowes for $7, you can make a TON of these with it.
Directions:
Cut a piece of polycarbonate at 14-15mm diameter. You can use a hole saw in
Materials:
I printed mine out of generic TPU, strength here is plenty.
I found my 0.093in 8x10in sheet of polycarbonate at Lowes for $7, you can make a TON of these with it.
Directions:
Cut a piece of polycarbonate at 14-15mm diameter. You can use a hole saw in
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
