Thingiverse
M8 washer 3cm
por DarkoDDio
29
Descargas
13
Likes
1
Makes
There is also a little spacer near the hole
Version 2: After printing I noticed that the 8mm whole was too tight
So I increased it by .1 mm in V2
I've also noticed that must be printed without raft to have a better bottom layer
Version 2: After printing I noticed that the 8mm whole was too tight
So I increased it by .1 mm in V2
I've also noticed that must be printed without raft to have a better bottom layer
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
