Slicer Discord
M900 Front Plate – 3D printable model from MakerWorld MakerWorld
Electronics

M900 Front Plate

1 Downloads
1 Likes
0 Makes
Go to Model
Front Cover for Lenovo M900 incase you don't need power or usb and aux. CD Cover is coming soon, should be similar. Make sure to unscrew the usb and take off the metal plate and push the usb back to make sure that it will fit. FOR THE CD SECTION:Blocks the CD Drive. Do note you need to remove it before installing the cover. HOW TO PUT IN:Open the case by sliding off the side.Pull the tabs off that hold the front in.Remove the front----For CD:1. Pull up on the blue tab that says 12. Slide the drive out from the back3. Unplug Cables----Remove the original covers by undoing the smaller clips holding in each part of the caseUnscrew the USB bracket (Phillips Head)Bend the bracket off of the USB & AUX Box's Plastic ContainerRemove the bracket (you can throw it away now)bend the USB Box up and push it in (so that it is fully inside of the slot it was inside)Push on the new coverDone!
Category
Electronics
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
PLA, ABS
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection