Thingiverse
MacBook Pro mount - Under desk - Wall
von dsorgio
90
Downloads
78
Likes
0
Makes
This is my first design ! I have not printed it yet and do not know how strong it is. I recommend to print in PETG for extra strength.
This was made to hold my MacBook Pro under my desk while not in use. It will accommodate any MacBook or other laptop that is 28mm or less in total thickness. There is 2 files one for Right side and one for Left side.
Print with the writing facing the build plate. The bottom holes were made to accommodate a standard 7mm screw driver bits, and the top holes are 4mm in diameter. You can mount with wood screws into you desk or wall at any of the holes.
Made for a 2011 MacBook Pro 15" thickness but will fit pretty much all MacBooks ! 13" and 15" MacBook pros from 2008 to mid 2012 are the same thickness.
This was made to hold my MacBook Pro under my desk while not in use. It will accommodate any MacBook or other laptop that is 28mm or less in total thickness. There is 2 files one for Right side and one for Left side.
Print with the writing facing the build plate. The bottom holes were made to accommodate a standard 7mm screw driver bits, and the top holes are 4mm in diameter. You can mount with wood screws into you desk or wall at any of the holes.
Made for a 2011 MacBook Pro 15" thickness but will fit pretty much all MacBooks ! 13" and 15" MacBook pros from 2008 to mid 2012 are the same thickness.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
