Machinist tool box

Toolbox I built to hold my minimal machinist tools.
Has pocket on top for a Mitutoyo 6" caliper
top drawer has pocket (divider) for an Altoids tin. Print two tops if you don't want the tin pocket


I had to cut the main body into 3 parts to successfully print this (using bambu slicer w/joining holes/pegs) epoxied the printed parts together. I cut the box right below the drawer separator (so the two bottom parts were open),

With full support in the drawer area the print kept lifting and warping. 3 pieces worked great, maybe your printer is better (I used a Bambu A1) and can do one piece.

Latches are from Amazon.

https://www.amazon.com/dp/B07VPD8X9S?ref=ppx_yo2ov_dt_b_fed_asin_title

Also needed:
4x 1/4-20 x.75 shcs (handle mounts)
4x 1/4-20 nuts
9x m3x6 shcs (hinge stop, latch mounts)
9x m3 nut (hinge stop, latch mounts)
2x m3 x 18 (or 20) drawer latch
2x m3 nuts drawer latch
2x springs for latch (I used pen springs, cut to length) dia 5mm ish x 10-12ish
.12