Mage Knight: Magnetic Hex Tile Frames

# Magnetic Tile Holder
Was inspired by the other [Magnetic Tile Holder](https://www.thingiverse.com/thing:536422/files) However, since it was not completed. I have since created my own version with some tweaks:

1. Thinner Inner Base: This will reduce material usage and reduce print time, whilst still holding the tiles in place if lifted.
2. Increased Inner Radius: Improves fitting of the tiles and removes the need to push them in (especially if your printer is a bit innacurate). I find they fit snug whilst avoiding any damage to the edges.

# Requirements
You will obviously need magnets and some type of adhesive, I just used a hot glue gun.
1. 3mm x 1.5mm Magnet: https://www.amazon.ca/gp/product/B07FY9CGBL/ref=ppx_yo_dt_b_asin_title_o01_s02?ie=UTF8&psc=1
- The above comes with 200 and each tile takes about 18 magnets, so you should be able to make about 11 of them.
2. Adhesive: I used a hot glue gun.

# Misc
If you find the inner radius too loose try scaling it a