Thingiverse
Magellan RoadMate Replacement GPS Mounting Base
por rebeltaz
0
Descargas
2
Likes
0
Makes
The suction cup mount for my Magellan RV9165T-LM RoadMate GPS busted so I was looking for another way to mount it. I decided to model it after the dashmount for an old iQue3600 Palm Pilot / GPS. This is the result. It utilizes the original GPS mount and the attached ball-jointed arm, along with the original toothed inserts.
This is assembled like so:
bolt > mount > washer > insert > arm > insert > washer > mount > nut
Once the nut is tightened the arm is locked in position. You can then either mount the base to the dash with double sided adhesive and/or self tapping screws. I left the screw holes small so that you can drill them out to the size needed if you decide to go that way.
---
*Another Sketchup Model - Debunking the Myth that Sketchup is Useless in 3D Printing*
This is assembled like so:
bolt > mount > washer > insert > arm > insert > washer > mount > nut
Once the nut is tightened the arm is locked in position. You can then either mount the base to the dash with double sided adhesive and/or self tapping screws. I left the screw holes small so that you can drill them out to the size needed if you decide to go that way.
---
*Another Sketchup Model - Debunking the Myth that Sketchup is Useless in 3D Printing*
rebeltaz también publica en
253 modelos adicionales en 3 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
