Thingiverse
MagHex Holder
by Xevin
484
Downloads
221
Likes
0
Makes
MagHex Holder
----------------------
All my MagHex prints were getting messy, so I made this to keep it organized.
###Features
* Holds all your MagHex Tiles and tops together and keeps them organized
* Each stack holds 50 MagHex tiles, or ~150 tile tops
* Uses just a few rubber bands to hold everything together. (no magnets, sadly)
###Notes
* Stacks print in vase mode ("Spiralize Outer Contour" in Cura). Set "bottom thickness" to 2mm to print the base solid.
* Takes a minimum amount of filament and time. About 70g for each Endcap and 240 for the Case.
###Changelog
03.19.2020
* Huge redesign of this thing.
* Made the Endcaps deeper to hold the stacks better
* Made the Case optional in the design to save filament
06.03.2019
* First upload of the design.
----------------------
All my MagHex prints were getting messy, so I made this to keep it organized.
###Features
* Holds all your MagHex Tiles and tops together and keeps them organized
* Each stack holds 50 MagHex tiles, or ~150 tile tops
* Uses just a few rubber bands to hold everything together. (no magnets, sadly)
###Notes
* Stacks print in vase mode ("Spiralize Outer Contour" in Cura). Set "bottom thickness" to 2mm to print the base solid.
* Takes a minimum amount of filament and time. About 70g for each Endcap and 240 for the Case.
###Changelog
03.19.2020
* Huge redesign of this thing.
* Made the Endcaps deeper to hold the stacks better
* Made the Case optional in the design to save filament
06.03.2019
* First upload of the design.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
