Magic Band Holder

This Magic Band holder printed with ender 3 and Geeetech A10M Printers is a gift I made for my sisters magic band collection that can hold around 15 bands and can be printed in 4 pieces. Each piece is printed at 100% and can also be scaled to fit your printer if desired. I printed it in PLA and in only 3 separate prints. I will add the Gcode I used and you can disect the settings if you wish. The ears are 105 grams in total, the face is 93 grams and the stand was around 100 grams all printed with 10% infill. I suggest printing the face and face up and just support the attachment point with infill the tolerances are about 1mm so it should work with most if not all printers. The ears were Glued/epoxied onto the face with silicone paper (Parchment paper) under them to keep level and not stuck to the table. Because my printer isn't perfect I had to use folded tissues to level the ears with the face. I could have Ironed the ears but I was in a rush to make it.