Slicer Discord
Magic Block Piercing Trick – 3D-Druckmodell von Thingiverse Thingiverse

Magic Block Piercing Trick

von dnewman
482 Downloads
371 Likes
5 Makes
Zum Modell
Hocus Pocus! You present your audience with six colored blocks, each one with a hole through its face. Your audience inspects the blocks as well as the box you will place them in and the pin you will pierce them with. A volunteer selects two of the six blocks. After placing all six blocks into the box, you pierce the box and all the blocks with a pin. Waving your hand over the box, you say a magic word. Turning the box upside down, the lid falls off and out drops the two chosen blocks! But wait the pin is still running through the box with the remaining blocks still pinned in place!

See the demo video http://youtu.be/pmZhGH7pSUo

Print this magic trick along with Thing 24719,

http://www.thingiverse.com/thing:24719

and put on an impromptu magic show! You'll be sure to amaze your friends and family.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen