Slicer Discord
Magic Card Box for Commander – 3D-Druckmodell von Thingiverse Thingiverse

Magic Card Box for Commander

13 Downloads
16 Likes
0 Makes
Zum Modell
Card Box for Magic: The Gathering to hold a deck for the Commander format. It has a compartment for 100 cards plus extra space for token cards in a separate compartment.

The commander can be displayed on the top side of the box in a dedicated window, where a sheet of plexiglass can be inserted to protect the commander card. The commander card can be inserted and removed by a slot on the backside of the lid. On the inside of the lid a small area is cut out to get the commander card out of its slot.

The lid holds in place by small rails. To remove the lid, move the lid forwards and then upwards. The cards inside give a bit of resistance so the lid does not open accidentally if the are sleeved, but not too much that it would damage the cards in any way. The bottom of the box is engraved with the land symbols, just for the extra aesthetics :)
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen