Thingiverse
Magic chef replacement ice bucket
door nickynick123
9
Downloads
4
Likes
0
Makes
Replacement ice "bucket" for my magic chef ice maker. Mine cracked and started leaking rusty water from the motor and the alternative is $35 here (http://www.appliancezone.com/mcim22ts-tw-02-magic-chef-ice-machine-bucket/
of 37 from amazon (https://www.amazon.com/Magic-Chef-MCIM22TS-TW-02-Bucket/dp/B01GTLXZ2S/ref=sr_1_1?ie=UTF8&qid=1504117340&sr=8-1&keywords=mcim22ts)
NO GUARANTEES THIS IS YOUR ACTUAL PART, FIND OUT YOUR MODEL NUMBER AND DO YOUR OWN RESEARCH!
This is pretty much the final design, but you may find the cut angle isn't quite right. I recommend printing it as two parts because it's just beyond a 200mm bed, but also because you can they adjust angle of the D-cut shaft. Just bolt on with a 40(?)mm m3 bolt, nut and locking washer, I would also use a 006/007 oring or rubber washer. If you are going to use the single piece version, I would verify the angle and let me know if it's off.
of 37 from amazon (https://www.amazon.com/Magic-Chef-MCIM22TS-TW-02-Bucket/dp/B01GTLXZ2S/ref=sr_1_1?ie=UTF8&qid=1504117340&sr=8-1&keywords=mcim22ts)
NO GUARANTEES THIS IS YOUR ACTUAL PART, FIND OUT YOUR MODEL NUMBER AND DO YOUR OWN RESEARCH!
This is pretty much the final design, but you may find the cut angle isn't quite right. I recommend printing it as two parts because it's just beyond a 200mm bed, but also because you can they adjust angle of the D-cut shaft. Just bolt on with a 40(?)mm m3 bolt, nut and locking washer, I would also use a 006/007 oring or rubber washer. If you are going to use the single piece version, I would verify the angle and let me know if it's off.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
