Thingiverse
Magic Wand
von kamondelious
5
Downloads
9
Likes
0
Makes
A simple classic style magic wand.
The pieces are meant to be printed standing on end, so make sure you have good bed adhesion. Supports are needed on the connector piece.
As pictured, I used 2x WandTips, 2x WandShafts and 3x WandConnectors. I have played at attaching more shafts together, for more of a walking stick type look and it seems to hold up well.
I have printed a few of these for my kids to play with and they have been enjoying them.
I recommend a higher infill setting for the WandConnector pieces. 15% works, but will not hold up well to children.
The pieces are meant to be printed standing on end, so make sure you have good bed adhesion. Supports are needed on the connector piece.
As pictured, I used 2x WandTips, 2x WandShafts and 3x WandConnectors. I have played at attaching more shafts together, for more of a walking stick type look and it seems to hold up well.
I have printed a few of these for my kids to play with and they have been enjoying them.
I recommend a higher infill setting for the WandConnector pieces. 15% works, but will not hold up well to children.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
