Thingiverse
Maglite Mini Magnet
von c93010
5
Downloads
11
Likes
0
Makes
Magnetic mount for Maglite Mini. The six holes in rear are for magnets and are 10mm x 2mm.
If you are using 10mm round magnets then you can get away with only using four magnets. If you are using smaller (6mm or 8mm) I recommend using 6 magnets. Glue magnets in place.
I used 10mm x 3mm magnets so they stick out a little out the back which is fine.
If you are using 10mm round magnets then you can get away with only using four magnets. If you are using smaller (6mm or 8mm) I recommend using 6 magnets. Glue magnets in place.
I used 10mm x 3mm magnets so they stick out a little out the back which is fine.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
