Thingiverse
Maglite wall holder
door 343guiltysparkhalo
142
Downloads
90
Likes
1
Makes
A wall holder for a 6 cell D battery ML300l maglite flashlight. This is the heaviest maglite so the holder should work for all of the big sized ones.
Printed at 0.2 on an ender 3 with 30% cubic infill using cura. Very strong. seems like it will tear out of the wall before the plastic breaks (i tried).
Only hardware required is screws. I believe the head size was 9mm and the screw hole was 5mm
Printed at 0.2 on an ender 3 with 30% cubic infill using cura. Very strong. seems like it will tear out of the wall before the plastic breaks (i tried).
Only hardware required is screws. I believe the head size was 9mm and the screw hole was 5mm
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
