Thingiverse
Magnet man
40
Downloads
34
Likes
0
Makes
This is 3D printed astronaut that is size compatible with Starcom toys from the '80s. It is also compatible with my Martian rover toy design.
The holes in the bottom of the feet are sized to press-fit Primal Horizon Magnets (1/8" x 1/16") (I found mine using amazon).
To assemble I glued the plugs into the main body. The leg hinge I printed the pin joints and then shoved them through and used the hot end of a glue gun to melt them a little bit to close them off.
The holes in the bottom of the feet are sized to press-fit Primal Horizon Magnets (1/8" x 1/16") (I found mine using amazon).
To assemble I glued the plugs into the main body. The leg hinge I printed the pin joints and then shoved them through and used the hot end of a glue gun to melt them a little bit to close them off.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!