Thingiverse
Magnet Tray
door ImAThingsGuy
7
Downloads
8
Likes
0
Makes
It is what it is, a magnet tray, it uses 4x4x4mm neodymium magnets pressed into the base either by hand or with a soldering iron.
I needed a magnet tray for some very small screws and I had it on my desk within 45 minutes after the idea, i was quite excited about it.
hope you enjoy
I needed a magnet tray for some very small screws and I had it on my desk within 45 minutes after the idea, i was quite excited about it.
hope you enjoy
ImAThingsGuy publiceert ook op
17 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
